Wine Guardian Through-the-Wall Installation, Operation And Maintenance Manual page 22

Through-the-wall wine cellar cooling systems

Hide thumbs Also See for Through-the-Wall:

Table of Contents

Step 4

Fasten the EasyMount

sleeve to the wall studs through the six (6) pre-drilled holes located on either

side of the EasyMount

sleeve. Starting at location (1) insert a wood screw into the pre-drilled hole

and tighten the screw until it is snug. Do no over tighten. Continue to the number (2) Through (6)

positions and tighten until all are snug. Do not over tighten. Once each screw has been installed repeat

the progression (1) through (6) so that each screw is tight. Ensure screws are inserted flush with wall

sleeve inside surface.

Step 5

Slide the Wine Guardian Through-the-Wall system through the EasyMount

sleeve to the desired

depth.lease note the Through-the-Wall system must be slid so that the power cord side is last, not

first, to enter the sleeve. Do not slide the system past the desired flush mounting point.

Table of Contents

24s025