Starting-Up And Operating The Wine Guardian; Control Settings; Controller Functions - Wine Guardian WG15 Installation, Operation And Maintenance Manual

Wine cellar cooling systems through-the-wall wine cellar cooling systems

Hide thumbs Also See for WG15:

Table of Contents

Starting-up and Operating the

Wine Guardian

ON/OFF – The ON/OFF button will be used to turn the system on or off. When set to the off

mode the control will not allow any of the outputs to energize effectively locking the system

out. It will not allow any outputs to energize until the system is turned on with the ON/OFF

button. It should be noted that high voltage will still be present at the main control board when

the system is set to off even though the control will not allow it to switch to the outputs.

UP Arrow – The UP arrow will allow the user to increase settings.

DOWN Arrow – The DOWN arrow will allow the user to decrease settings.

MODE – The MODE button will be used to select between HEAT, COOL and AUTO MODE,

as well as entering the configuration settings. Holding the MODE button for 5 seconds will

enter configuration mode. Once in configuration mode the user can adjust settings by pressing

the UP or DOWN arrows. Pressing the MODE button once will advance to the next

configuration settings. Holding the MODE button for 5 seconds while in configuration mode

will store all changes and exit configuration mode.

For cooling operation only: Cooling is set at 13°C from the factory. This can be changed by

hitting the UP or DOWN arrow, but please refer to configuration settings # 2 and # 3 for

limitations in comparison to the High and Low temperature alarm settings.

For units with optional humidifier controlled by TTW WG: The RH% is factory set at

55%. This can be changed by referring to configurations setting # 6. If no humidifier is

attached, the control will read RH%, but will not be controlling it.

Changing fan operation: The default setting from the factory is "AUTO" fan. If desired it can

be changed to fan "ON" by accessing configuration setting #

The control has been wired and set up in the factory for testing with

default settings. It is an electronic digital thermostat for one-stage

cooling. No additional adjustments should be necessary except

adjusting the cellar temperature to your preference. If additional

adjustments or changes are necessary, please refer to the

configuration settings section in this manual.

Table of Contents

Wg25