Installing The Ups - Avaya S9RM Installation And Operator's Manual

Installing the UPS

NOTE Do not make unauthorized changes to the UPS or accessories; otherwise, damage
may occur to your equipment and void your warranty.
Figure 11 shows a typical installation only. See "UPS Rear Panels" on
page 29 for the rear panel of each model.
To install the UPS and optional EBMs:
1.
2.
UPS Battery
Connector
EBM Cable
3.
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power
requirements of the heating elements.
4.
t
Avaya
If installing an optional EBM, continue to Step 2; otherwise, skip to
Step 3.
Plug the EBM cable(s) into the battery connector(s) as shown in
Figure 11. Up to four EBMs may be connected to the UPS.
ConnectUPS-X Web/SNMP Card
UPS
EBM
EBM
Figure 11. Typical UPS Installation with Two EBMs
Plug the equipment to be protected into the appropriate UPS output
receptacles (see page 47 for more information on load segments).
If an emergency power-off (disconnect) switch is required by local
codes, see the following section, "Remote Emergency Power-off
Installation," to install the REPO switch before powering on the
UPS.
S9RM UPS Site Preparation, Installation and Operator's Manual
Power Cord Output Receptacles
EBM Battery Connectors
S
05147387 Rev C
INSTALLATION
25