Preheat Hoses - Graco EnergyComplete 313221H Instructions - Parts Manual

Preheat Hoses

The ambient temperature must be greater than 40°F
(4.4°C).
If the ambient temperature is below 70°F(43.3°C) it is
required to preheat the hoses.
Connect circulation lines (CL) to circulation manifold
(701). Route circulation lines (CL) back to red and white
fluid pails.
1.
Remove block (702). Install circulation manifold
(701) on gun fluid manifold (GM). Open all
valves in the fluid circuit.
A
GM
701
CL
2.
Perform Startup, page 18.
3.
Close fluid valves A and B. Remove circulation
manifold (701) from gun fluid manifold (GM).
Attach block (702) to circulation manifold to pre-
vent air from reacting with EnergyComplete Air
Infiltration Barrier.
313221H
B
702
CL
TI4063a
Setup
17