Setup - Graco EnergyComplete 313221H Instructions - Parts Manual

Setup

1.
Locate EnergyComplete Sprayer
Locate EnergyComplete Sprayer on a level surface. Do
not expose EnergyComplete Sprayer to rain.
2.
Electrical Requirements
Improper wiring may cause electric shock or other
serious injury if work is not performed properly. Have
a qualified electrician perform any electrical work. Be
sure your installation complies with all National, State
and Local safety and fire codes.
Connect EnergyComplete Sprayer to the correct power
source for your model. See T
three power cords must be connected to separate, dedi-
cated circuits. See F . 5.
IG
3.
Grounding
The equipment must be grounded. Grounding reduces
the risk of static and electric shock by providing an
escape wire for the electrical current due to static build
up or in the event of a short circuit.
• EnergyComplete Sprayer: grounded through power
cord.
• Generator (if used): follow your local code. Start and
stop generator with power cord(s) disconnected.
• Spray gun: grounded through the supplied fluid
hoses, connected to a properly grounded Energy-
Complete Sprayer. Do not operate without at least
one grounded fluid hose.
12
2. Models with two or
ABLE
• Object being sprayed: follow your local code.
• Solvent pails used when flushing: follow your local
code. Use only metal pails, which are conductive,
placed on a grounded surface. Do not place pail on
a nonconductive surface, such as paper, plastic, or
cardboard, which interrupts grounding continuity.
• To maintain grounding continuity when flushing or
relieving pressure, hold a metal part of spray gun
firmly to the side of a grounded metal pail, then trig-
ger gun.
Setup
313221H