Component Identification
Motor Power
Power Switch
Switch
Motor
Motor
Power
Switch
The motor power switch (S) must be in the ON for the
sprayer to pump material.
Motor Power
Power Switch
Switch Settings:
Settings:
Motor
Motor
Power
Switch
Settings:
OFF
Power is off. The motor will not run.
The motor will run continuously at
ON
a speed determined by the flow
adjustment knob.
10
All manuals and user guides at all-guides.com
Connect Hoses
Connect
Connect
• Before connecting hoses/applicator, inspect for
damage or wear to both the hose/applicator and
cam lock fittings. Fittings should be clean and free
of debris, dents, cracks or nicks. The female cam
lock fitting must have the gasket installed.
• Always connect hoses from largest diameter to
smallest diameter.
• Use a minimum of 25 ft of hose with a working
pressure of at least 600 psi (4.1 MPa, 41 bar).
• When fastening cam locks, make sure the pull ring
stays to the outside of the cam lock arm to allow
for complete and proper sealing of the cam lock.
Once installed, use Velcro straps to secure cam
locks in place.
Hoses and
and Applicator
Applicator
Hoses
and
Applicator
3A3437F