Connecting The Digital Capture Unit To A Network - Sony UPA-P100MD User Manual

Connecting the Digital
Capture Unit to a
Network
The Digital Capture Unit can be connected to a
network, but before you connect it to a network
environment, you must configure it appropriately.
Follow the procedure below to adjust these settings.
Refer to the next section "The Configuration Screen"
for a more detailed description of the configuration
screen's contents.
Note
• Please use Windows computers to configure and
access the UPA-P100MD. Other operating
environments are not supported by the UPA-
P100MD.
• The procedures in this guide are based on Windows
98 dialog boxes and windows. Screen appearance
may differ slightly in other Windows versions.
1
Using an RJ-45 cross cable (10Base-T or 100Base-
TX), connect the UPA-P100MD directly to the
appropriate network interface on your computer.
2
Turn on the unit and wait until it is ready for
operations.
3
On your computer, start your Internet browser.
Note
Before you proceed to step 4, make sure that your
Internet browser does not use a proxy server.
4
In the [Address] bar of your browser, type
http://192.168.3.200/
The Sony UPA-P100MD screen opens.
5
Click [Configuration]. The Sony Digital Capture
Unit UPA-P100MD Configuration screen opens.
14