Remote Control Port Pin
This port is reserved for the RM-P110 Remote Control
Unit. Connecting another device to this port could
cause it to malfunction.
Male connector of the RM-P110
Remote Control Unit connection cable
DC 5 V (maximum 500 mA)
R × D
T × D
RI (Not supported by the unit at this time)
This connector outputs 5 V; therefore do not connect it
to any device other than the RM-P110 Remote Control
Unit or other control device designed for use with the
UPA-P100MD. If you connect a device other than the
remote control to this connector, there is a risk of
damage to the device.
The screws of the remote control port of the Digital
Capture Unit are threaded in inches. Make sure that
you have appropriate screws on the connector.