Multipurpose Management (Mng) Console Cable - Mellanox Technologies Grid Director 4036E Installation Manual

Grid Director 4036E Installation Manual
4. Route the cable to the nearest convenient rack location and gently fasten in place with
Velcro tie or tie wraps.
Cabling — Do's and Don'ts

For Port Cable Specifications, refer to
7.4

Multipurpose Management (Mng) Console Cable

For out-of-band management of a Grid Director 4036E, Mellanox provides a single
Multi-purpose cable kit (Figure
It contains the Mng cable and the two following adaptors:

RJ45 to RJ45 cable

A RJ45 to DB-9 cross-adaptor for RS-232 console connection (CLI). (The DB-9 adaptor
has a number 26 printed on it. This means that pins 2 and 6 are crossed).
CAUTION:
Avoid using tie wrap guns or similar tools; do not fasten the cables too tightly, as this may
cause irreversible damage.
Tie wraps and zip ties could cause potential damage to the cables. We recommend Velcro
tie.
Do not bend the InfiniBand cables too sharply. The minimum bend radius is 4" (10 cm).
Do not kink the cable
Do not over-bend the cable behind the connector
Do not twist the connector
‎
7 -6).
Cabling Information and Specifications (on page 54).
49