Option 2; Figure 11: 4036E - Option 2 Assembly - Mellanox Technologies Grid Director 4036E Installation Manual

High-bandwidth, low-latency scalable grid director

Table of Contents

6.6.3

Option 2

This option describes how to assemble and mount the rail and install the switch where the rear

of the switch (InfiniBand connector side) faces the front of the rack. This rear-to-front chassis

installation is in-line with the vertical front rails of the rack.

Figure 11: 4036E – Option 2 Assembly



To mount the 4036E in a rack using Option 2:

1. Put the chassis on a flat surface.

2. On each side of the chassis, mount the short brackets on the rear side of the switch

(InfiniBand port side) using three 8-32x1/4" pan head Philips screws, as shown on the

picture.

NOTE: Mellanox does not provide standard rack clip nuts and rack screws.

Hardware Installation

Table of Contents

Show Quick Links

Table of Contents