Mellanox Technologies Grid Director 4036E Installation Manual page 35

Grid Director 4036E Installation Manual
Important: Left and right long brackets are different. Make sure that you are using the
correct bracket. The mounting ear at the end of the bracket should face out.
3. Position the mounting bar and adjust it according to the rack measurements you made in
Measuring the Distance between Mounting Rails
Note: Make sure that the distance is between 0.5" to 1" smaller than the distance you
measured between the two vertical rack rails.
Total distance = rack measurements you made in
Mounting Rails
4. Connect the mounting bar to the side of the switch using two 8 32x1/4" pan head Philips
screws using the top holes of the mounting bar.
Make sure to install one screw at the center of the switch and the second one at the rear of
the switch.
5. Repeat the above steps on the other side of the chassis.
6. Ensure that the clip nuts are already installed in the rack holes of the correct U level (on all
four vertical rack rails) as described in
(on page 32).
(on page 32).
Measuring the Distance between Mounting Rails
(on page 32).
Measuring the Distance between
35