Mellanox Technologies Grid Director 4036E Installation Manual page 36

High-bandwidth, low-latency scalable grid director
Table of Contents

Advertisement

Note: Mellanox does not provide rack clip nuts.
7. Place the power cords with the female connector facing the front of the rack (or the switch)
with approximately 10" hanging out of the front.
8. Route the other side (male connector) of the power cord to the rear of the rack. Do not
connect it to the PDU at this stage.
9. Lift and position the chassis, aligning the holes of all brackets with the rack holes of the
correct U level.
10. Gently push the switch inwards leaving it slightly protruded.
11. Place the power cords over the indentation of the long brackets.
36
Hardware Installation

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents