Mellanox Technologies Grid Director 4036E Installation Manual page 41

Grid Director 4036E Installation Manual
3. Mount the long bracket at the front of the chassis using two 8-32x1/4" pan head Philips
screws. Use the long bracket middle row orifices and the holes of top row on the rail. Note
that the left and right long brackets are different. Make sure that you are using the correct
bracket. The mounting ear at the end of the bracket should face out.
Important: At this stage, do not fully tighten the screws.
4. Position the mounting bar and adjust it according to the rack measurements you made in
Measuring the Distance between Mounting Rails
Note: Make sure that the distance is between 0.5" to 1" greater than the distance you
measured between the two vertical rack rails to allow adjustment at a later stage.
Total distance = rack measurements + 0.5 to 1" for adjustment.
(on page 32).
41