Receiving A Call; Sending A Call - Ericsson EDACS PRISM HP Operator's Manual

Receiving A Call

1. Turn on the radio by rotating the POWER ON-
OFF/VOLUME knob clockwise (out of detent). A
short alert signal (if enabled through programming)
indicates the radio is ready to use.
2. Adjust the POWER ON-OFF/VOLUME knob to the
desired volume level.
3. Select the desired conventional system and chan-
nel. The display indicates the current conventional
system and channel names.
4. The radio is now ready to receive calls.
5. When the radio receives a call (and the correct
encoding is decoded, if programmed and enabled),
it unmutes on the channel and

Sending A Call

1. Turn on the radio and set the POWER ON-OFF/VOL-
UME knob to the desired volume level. Select the
desired conventional system and channel.
2. Ensure that the channel is not busy by pressing the
CLEAR/MONITOR button to momentarily disable
any channel decoding and unmute the receiver or
observe the display for the absence of
Channel Busy Lockout feature is programmed for
the selected channel, the radio will not transmit when
the channel is busy.
comes on.
. If the
83