Starting Or Stopping Scan; Receiving A Call; Ending A Call - Ericsson TRUNKED MDX Operator's Manual

Starting Or Stopping Scan

1. Press the SCAN button until either the "SCN" indicator goes off or
on.
1. The radio will remember the scan state through a power cycle
unless programmed with a predefined power up state.
2. The radio may be programmed to stop scanning when the micro-
phone is removed from teh hookswitch.
3. When the radio is programmed, a FIXED SCAN list can be
specified. If this is done, the SCAN list cannot be changed.

RECEIVING A CALL

When a call is received by the radio, the call is decoded. A single alert tone
will sound indicating a group call has been received or a two tone alert will
sound if an individual call has been received. The display will show the system
or area and group when receiving a group call and the system or area and
individual decode when an individual call is received. If the calling party's
name is not found, their five digit ID will be displayed instead.
If a dispatch call is desired, simply pick up the microphone and press the
PTT to transmit to the caller.

ENDING A CALL

The call can be terminated in one of three ways:
METHOD 1: Press CLR.
METHOD 2: A system disconnect or time out occurs. During a dispatch
NOTE
call the time out occurs after 6 seconds of channel silence.
During an interconnect call the time out occurs after 30
seconds of channel silence.
27