Table of Contents
Advertisement
3. Press and hold the PTT button. The radio will display
and a short beep sounds (if programmed) indi-
cating that communication can begin.
4. Hold the radio approximately three inches from the
mouth and speak in a normal voice into the micro-
phone (located at upper left front corner).
5. Release the PTT button when the transmission is
complete and listen for a reply.
The following procedures outline scan operations for
conventional channels.
Adding Channels To A Scan List
1. With scan operation turned off select the desired
channel to add to the selected conventional system
)
channel scan list.
2. Press
status will be displayed in column 1 of line one for a
time-out period. Press
channel to the scan list. S is displayed on the line.
This sets the selected channel for non-priority scan-
ning. A second press of
nel for priority-two scanning and 2 is displayed on
line one. An additional press of
the channel for priority-one scanning and 1 is dis-
played on line one. If the priority-one or priority-two
channels are already set and a new channel is then
assigned as the priority-one or priority-two channel,
the previously assigned priority channel will change
84
$
)
(Scan) or
)
$
(System). The current
or
to add the
$
)
or
sets the chan-
or
$
sets
Advertisement
Table of Contents
