Data Off Operation; Data On Operation; Exiting Data Calls - Ericsson EDACS PRISM HP Operator's Manual

Radios

Table of Contents

DATA OFF OPERATION

The radio can be placed in the data disabled state by

any of the following methods. When the data state is

disabled, the display shows "DATA OFF" on the top line.

• • Declaring an emergency (not to be used unless an

actual emergency condition exists). Alert tone will

sound.

• • Pressing the OPTION button (if pre-programmed for

no data key). Alert tone will sound.

• • Pressing the no data (ND) key (pre-programmed).

The data state is enabled by one of the following

(depending on how it was disabled). "DATA ON" will be

displayed on the top line in the display for two seconds

then the display returns to normal.

• • Pressing the no data (ND) key toggles data state on

or off.

• • Clearing an emergency but valid only if emergency

caused data off operation.

Under normal conditions, the radio enters the scan

lockout mode and returns to the control channel after

completion of a data call (transmit or receive). If, during

a data call,one of the following conditions occurs, the

Table of Contents