Scsi Requirements - Silicon Graphics 1450 Maintenance Manual

SCSI Requirements

!
007-4276-001
7. Connect the power and signal cables to the drive.
8. Install the front cover. See "Installing the Front Cover" on page 24.
All SCSI devices must not be terminated except the peripheral at the end of the SCSI
cable.
Note: Integrating the 5.25-inch peripheral bay can affect EMC compliance and is a
regulated activity. Except as noted here, any changes to the bay configuration could
result in noncompliance with EMC regulations.
Caution: To avoid damage to a 5.25-inch peripheral device, ensure the EMI gasketing
provided in the device bay does not bridge any open circuits on the exposed peripheral
device.
SCSI Requirements
47