Figure 2-3 E-Bay Retaining Screws - Silicon Graphics 1450 Maintenance Manual

2: Removing and Installing System Components
30
18. Remove the plastic slot dividers. First, pull up on the end at the front of the E-Bay,
and then slide the other end out of the back panel at the back of the E-Bay.
19. Remove the screws securing the baseboard to the chassis. There should be two of
them.
20. Remove the four screws on the top and bottom edges of the rear subchassis. These
screws attach the E-Bay to the chassis. Two of the four screws are noted as "A" in
Figure 2-3.
A
Figure 2-3 E-Bay Retaining Screws
21. Pull the E-Bay away from the chassis. As you separate the E-Bay away, make sure
that the power cord does not become wedged between the two parts of the chassis.
22. Remove the rug from the E-Bay.
23. Using needlenose pliers, remove the plastic rear retention mechanism located at the
front of the E-Bay. The rear retention mechanism is noted by "A" in Figure 2-4 on
page 31.
24. Slide the baseboard towards the front of the chassis.
25. Lift the baseboard up and out on the side closest to the baseboard and VRM
connectors.
007-4276-001