Solving Problems; Resetting The System; Initial System Startup; Table 4-1 Resetting Commands - Silicon Graphics 1450 Maintenance Manual

4.

Resetting the System

Initial System Startup

007-4276-001
Chapter 4

Solving Problems

This chapter helps you identify and solve problems that might occur while you are using
the system.
Table 4-1 shows the commands used to reset the system.
Table 4-1 Resetting Commands
To do this:
Clear system memory, restart POST, and reload the operating
system.
Cold boot reset, which clears system memory, restarts POST,
reloads the operating system, and stops power to all peripherals.
Problems that occur at initial system startup are usually caused by incorrect installation
or configuration. Hardware failure is a less frequent cause. Use the following check list
to troubleshoot Startup problems:
• Are all cables correctly connected and secured?
• Are the processors fully seated in their slots on the baseboard?
• Are all PCI add-in boards fully seated in their slots on the baseboard?
• Are all switch and jumper settings on the baseboard correct?
• Are all jumper and switch settings on add-in boards and peripheral devices correct?
To check these settings, see the manufacturer's documentation. If applicable, ensure
Press:
Reset button or <Ctrl+Alt+Del>
Power off/on
75