Unpacking And Inspecting The Server; Determining Space Requirements; Observing Pre-Installation Safety Precautions - Silicon Graphics 1450 Mounting Instructions

SGI 1450 Server Mounting Instructions

Unpacking and Inspecting the Server

Determining Space Requirements

Observing Pre-Installation Safety Precautions

2
Remove the server from the packaging container and check that all accessories are
included. Inspect the packaging container for evidence of mishandling during transit. If
the packaging container is damaged, photograph it for reference. After removing the
contents, keep the damaged container and the packing materials.
Inspect the server and accessories for damage. If the contents appear damaged, file a
damage claim with the carrier immediately.
The SGI 1450 Server is designed either to be mounted in a standard 19-inch rack (rack
mode) or to stand upright (pedestal mode).
The following table specifies the space requirements for the SGI 1450 Server system in
rack mode.
SGI 1450 Server Physical Specifications
Table 1
Specification
Height
Width
Depth
Weight
Required front clearance
Required rear clearance
Required side clearance
Read the following warnings and cautions before proceeding with the installation.
Rack Mode
4u (7 inches)
17.5 inches (44.5 cm)
26.5 inches (67.3 cm)
57 lbs (26 kg), minimum configuration
88 lbs (40 kg), maximum configuration
3 inches (inlet air temperature <35 °C / 95 °F)
6 inches (no airflow restriction allowed)
1 inch
007-4242-001