Removing The Hard Drive Bay; Figure 2-9 Hard Drive Bay Tabs - Silicon Graphics 1450 Maintenance Manual

Removing the Hard Drive Bay

007-4276-001
To remove the hard drive bay, follow these steps;
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Remove the front cover. See "Removing the Front Cover" on page 23.
3. Remove the fan board assembly. See "Removing the Fan Board Assembly" on
page 39.
4. Disconnect the four cables attached to the hard drive bay.
5. Remove the SCSI hard drives. See "Removing a SCSI Hard Drive" in the SGI 1450
Server User's Guide.
6. With a flat head screwdriver, press the two tabs inward on one side. Repeat this step
for the two tabs on the other side. The two tabs are noted by "A" in Figure 2-9.
Figure 2-9 Hard Drive Bay Tabs
Hard Drive Bay
A
43