Figure 2-2 Power Supply Ac Bracket - Silicon Graphics 1450 Maintenance Manual

007-4276-001
12. Remove the 33-MHz half-length PCI add-in boards. See "Removing a 32-bit,
33-MHz Half-Length PCI Add-in Board" on page 65.
13. Follow these steps to remove the power supply AC bracket:
a. Release the screw securing the connector. The screw is noted by "A" in
Figure 2-2.
b. Slide the bracket up and towards the inside of the chassis.
c. Drape the AC bracket over the left side of the E-Bay assembly.
A
Figure 2-2 Power Supply AC Bracket
A. Screw securing the connector
B. Power supply inlet connector
14. Remove the voltage regulator modules (VRMs). See "Removing a VRM" on page 62.
15. Remove the processors and any termination processors. See "Removing a
Processor" on page 59.
16. Remove the processor retention guides. See "Removing Processor Retention
Mechanisms" on page 59.
17. Remove any hot-plug PCI add-in boards. See the SGI 1450 Server User's Guide.
B
Baseboard
29