Ac Power Circuit Breaker Requirements For The Mx480 Router; Ac Power Cord Specifications For The Mx480 Router; Table 35: Ac Power Cord Specifications; Table 34: Ac Power System Specifications - Juniper MX480 Hardware Manual

Table 34: AC Power System Specifications (continued)
Item
Output power (maximum)
per system
Related
Documentation

AC Power Circuit Breaker Requirements for the MX480 Router

Related
Documentation

AC Power Cord Specifications for the MX480 Router

Table 35: AC Power Cord Specifications

Country
Australia
Copyright © 2011, Juniper Networks, Inc.
Appendix D: Power Guidelines, Requirements, and Specifications for the MX480 Router
Normal Normal-Capacity–High
Capacity–Low Line Line
3081 W 3200 W
Calculating Power Requirements for MX480 Routers on page 269
AC Power Circuit Breaker Requirements for the MX480 Router on page 277
AC Power Cord Specifications for the MX480 Router on page 277
Each AC power supply has a single AC appliance inlet located on the power supply that
requires a dedicated AC power feed. We recommend that you use a customer site circuit
breaker rated for 15 A (250 VAC) minimum for each AC power supply, or as required by
local code. Doing so enables you to operate the router in any configuration without
upgrading the power infrastructure.
AC Electrical Specifications for the MX480 Router on page 276
Calculating Power Requirements for MX480 Routers on page 269
AC Power Cord Specifications for the MX480 Router on page 277
Each AC power supply has a single AC appliance inlet located on the power supply that
requires a dedicated AC power feed. Most sites distribute power through a main conduit
that leads to frame-mounted power distribution panels, one of which can be located at
the top of the rack that houses the router. An AC power cord connects each power supply
to the power distribution panel.
You can order detachable AC power cords, each approximately 8 ft (2.5 m) long that
supply AC power to the router. The C19 appliance coupler at the female end of the cord
inserts into the AC appliance inlet coupler, type C20 (right angle) as described by
International Electrotechnical Commission (IEC) standard 60320. The plug at the male
end of the power cord fits into the power source receptacle that is standard for your
geographical location.
Table 35 on page 277 provides specifications and
on the AC power cord provided for each country or region.
Model Number
CBL-M-PWR-RA-AU
High-Capacity–Low High-Capacity–High
Line Line
3501 W 4100 W
Figure 120 on page 278
Electrical
Specification Plug Type
240 VAC, 50 Hz AC SAA/3/15
depicts the plug
277