Reinstalling The Scbs After Installing The Mx480 Router With A Lift; Figure 39: Reinstalling A Fan Tray - Juniper MX480 Hardware Manual

MX480 3D Universal Edge Router Hardware Guide

Reinstalling the SCBs After Installing the MX480 Router with a Lift

70

Figure 39: Reinstalling a Fan Tray

To reinstall an SCB (see Figure 40 on page
CAUTION: Before removing or replacing an SCB, ensure that the ejector
handles are stored vertically and pressed toward the center of the SCB.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Carefully align the sides of the SCB with the guides inside the chassis.
2.
Slide the SCB into the chassis until you feel resistance, carefully ensuring that it is
3.
correctly aligned.
Grasp both ejector handles, and rotate them simultaneously clockwise until the SCB
4.
is fully seated.
Place the ejector handles in their proper position, horizontally and toward the center
5.
of the board. To avoid blocking the visibility of the LEDs position the ejectors over the
PARK icon.
71):
Copyright © 2011, Juniper Networks, Inc.