Installing The Mx480 Router Without A Mechanical Lift; Tools Required To Install The Mx480 Router Without A Mechanical Lift; Removing Components From The Mx480 Router Before Installing It Without A; Lift - Juniper MX480 Hardware Manual

CHAPTER 8
Installing the MX480 Router Without a
Mechanical Lift

Tools Required to Install the MX480 Router Without a Mechanical Lift

Related
Documentation
Removing Components from the MX480 Router Before Installing It Without a Lift
Copyright © 2011, Juniper Networks, Inc.
Tools Required to Install the MX480 Router Without a Mechanical Lift on page 75

Removing Components from the MX480 Router Before Installing It Without a

Lift on page 75
Installing the MX480 Chassis in the Rack Manually on page 81
Reinstalling Components in the MX480 Router After Installing It Without a
Lift on page 83
To install the router, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11 mm) nut driver
ESD grounding wrist strap
Removing Components from the MX480 Router Before Installing It Without a Lift on
page 75
Installing the MX480 Chassis in the Rack Manually on page 81
Reinstalling Components in the MX480 Router After Installing It Without a Lift on
page 83
If you cannot use a mechanical lift to install the router (the preferred method), you can
install it manually. To make the router light enough to install manually, you first remove
most components from the chassis. The procedures for removing components from the
chassis are for initial installation only, and assume that you have not connected power
75