Replacing A Cable On An Mx480 Dpc, Mpc, Mic, Or Pic; Removing A Cable On An Mx480 Dpc, Mpc, Mic, Or Pic; Figure 106: Installing A Dual-Wide Mic - Juniper MX480 Hardware Manual

MX480 3D Universal Edge Router Hardware Guide
Related
Documentation

Replacing a Cable on an MX480 DPC, MPC, MIC, or PIC

Removing a Cable on an MX480 DPC, MPC, MIC, or PIC

206
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Use one of the following methods to bring the MIC online:
11.
Press the MIC offline/online button until the MIC
Issue the following CLI command:
user@host> request chassis mic fpc-slot mpc-slot mic-slot mic-slot online
The normal functioning status LED confirms that the MIC is online. You can also verify
correct MIC functioning by issuing the
in "Maintaining MX480 MICs" on page

Figure 106: Installing a Dual-Wide MIC

MPC
Dual-wide MIC
MX480 Modular Interface Card (MIC) Description on page 15
Maintaining MX480 MICs on page 129
Troubleshooting the MX480 MICs on page 150
Replacing an MX480 MPC on page 195
Preventing Electrostatic Discharge Damage to an MX480 Router on page 232
MX480 MIC Serial Number Label on page 301
Removing a Cable on an MX480 DPC, MPC, MIC, or PIC on page 206
1.
Installing a Cable on an MX480 DPC, MPC, MIC, or PIC on page 208
2.
Removing and installing cables on a DPC, MPC, MIC, or PIC does not affect router function.
To remove a cable:
Have ready a rubber safety cap for each fiber-optic cable and transceiver.
1.
If removing all cables connected to the component, use one of the following methods
2.
to take the component offline:
LED lights green.
OK/FAIL
show chassis fpc pic-status
129.
Copyright © 2011, Juniper Networks, Inc.
command described