Copyright © 2011, Juniper Networks, Inc.
Plug one end of the replacement cable into the
4.
shows the port.
Plug the other end of the cable into the network device.
5.
Figure 89: Cable Connector
Figure 90: Ethernet Port
Replacing the Console or Auxiliary Cable on an MX480 Router
To use a system console to configure and manage the Routing Engine, connect it to the
port on the Routing Engine. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the
AUX
port on the Routing Engine. Both ports accept a cable with an RJ-45
connector. One RJ-45/DB-9 cable is provided with the router. If you want to connect a
device to both ports, you must supply another cable.
To replace a cable connected to a management console or auxiliary device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the port.
2.
Disconnect the cable from the console or auxiliary device.
3.
Plug the RJ-45 end of the replacement serial cable into the
4.
Figure 91 on page 181
shows the external device ports on the Routing Engine.
Plug the female DB-9 end into the console or auxiliary device's serial port.
5.
Figure 91: Auxiliary and Console Ports
Chapter 14: Replacing MX480 Hardware Components
port.
Figure 90 on page 181
ETHERNET
CONSOLE
or
port.
AUX
181