Connecting The Mx480 Router; Tools And Parts Required For Mx480 Router Connections; Connecting The Mx480 Router To Management And Alarm Devices; Connecting The Mx480 Router To A Management Console Or Auxiliary - Juniper MX480 Hardware Manual

CHAPTER 9

Connecting the MX480 Router

Tools and Parts Required for MX480 Router Connections

Related
Documentation

Connecting the MX480 Router to Management and Alarm Devices

Connecting the MX480 Router to a Network for Out-of-Band Management
Copyright © 2011, Juniper Networks, Inc.
Tools and Parts Required for MX480 Router Connections on page 89
Connecting the MX480 Router to Management and Alarm Devices on page 89
Connecting DPC, MPC, MIC, or PIC Cables to the MX480 Router on page 92
To connect the router to management devices and line cards, you need the following
tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (–) screwdriver
2.5-mm Phillips (+) screwdriver
Wire cutters
Electrostatic discharge (ESD) grounding wrist strap
Connecting the MX480 Router to Management and Alarm Devices on page 89
Connecting the MX480 Router to a Network for Out-of-Band Management on page 89
Connecting the MX480 Router to a Management Console or Auxiliary Device on page 90
Connecting the MX480 Router to an External Alarm-Reporting Device on page 91
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45 connectors to the
Ethernet cable is provided with the router. To connect to the
Routing Engine:
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable
2.
the port on the Routing Engine.
ETHERNET
port on the Routing Engine. One
ETHERNET
ETHERNET
(Figure 56 on page 90 shows the connector) into
Figure 55 on page 90
port on the
shows the port.
89