Setting The Diffserv Parameters - Panasonic KX-NCP500 Networking Manual

4.5.3 Setting the Diffserv Parameters

Differentiated Services (DiffServ, or DS) is an IP-based QoS technique used to control QoS of VoIP
communications by setting the DS field in the header of IP packets. Consult your network administrator for the
appropriate setting values for the DS field.
Follow the procedure below to set the Diffserv parameters. Only KX-NT300 series IP-PTs and KX-NT265
IP-PTs (software version 2.00 or later) can be used to set the parameters.
Note
For details for the KX-NT400, refer to the Operating Instructions of the KX-NT400.
KX-NT300 series (except KX-NT321)
To start programming
SETUP
Press "SETUP"
when it is displayed.
To set the DS field value for the primary port
Select "Primary Port".
Diffserv
0.0–7.7
To set the DS field value for the secondary port
Return to the
Diffserv setting screen.
ENTER
To end programming
Return to the
Menu screen.
Document Version 2010-08
Select "Qos". ENTER
ENTER
ENTER
Select
"Secondary Port (TO PC)".
Diffserv
0.0–7.7
STORE
Press "STORE".
4.5.3 Setting the Diffserv Parameters
Select "Diffserv".
Select "Enable". ENTER
ENTER Select "Enable".
ENTER
The IP-PT will reboot
and can then be
registered to the PBX.
ENTER
IP Networking Guide 79