Panasonic KX-NCP500 Networking Manual page 65

For IP-PTs connected to the IP-EXT16 Card (KX-TDE series only)
1.
Using a DHCP server to automate the assignment of IP addressing information
The IP address of the IP-PT, the subnet mask address, and the default gateway address can be assigned
automatically by the DHCP server.
Only the IP address of the IP-EXT16 card (PBX IP address) must be assigned manually.
Follow the procedure below to assign the PBX IP address.
If you need to set VLAN parameters, follow the procedure described in "4.5.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
KX-NT300 series (except KX-NT321)/KX-NT136
To start programming
Supply power to the IP-PT.
To enter the IP address of the IP-EXT16 card (PBX IP Address)
Select "PBX".
ENTER
To enter the IP address of the Secondary PBX (optional for KX-NT300 with software
version 2.00 or later only)
Select "Secondary PBX".
To set VLAN parameters
To the VLAN settings
OR
To end programming
STORE
Press "STORE".
Document Version 2010-08
Press "SETUP"
when it is displayed.
KX-NT300 with software version 2.00 or later only
ENTER Select "PBX IP Address".
PBX IP Address
ENTER
The IP-PT will reboot
and can then be
registered to the PBX.
4.5.1 Assigning the IP Addressing Information
SETUP
ENTER
ENTER
PBX IP Address
Select "Primary PBX".
ENTER
IP Networking Guide 65