Panasonic KX-NCP500 Networking Manual page 55

3.
Not using a DHCP server when the IP-PT is on the same LAN with the PBX
Only the PBX IP address can be assigned automatically to the IP-PT in process of being registered to the
PBX. For details about registering the IP-PT, refer to "4.6.1 Registering IP Telephones".
Follow the procedure below to assign the IP address of the IP-PT, the subnet mask address, and the default
gateway address manually.
If you need to set VLAN parameters, follow the procedure described in "4.5.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
KX-NT300 series (except KX-NT321)
To start programming
Supply power to the IP-PT.
To set the IP address of the IP-PT
Select "Network".
IP Address*
To set the subnet mask address
Select "Subnet Mask".
To set the default gateway address (if required)
Select "Default Gateway".
To enter the IP address of the Secondary PBX (optional for software version 2.00 or
later only)
Return to the
Menu screen.
ENTER
Continued on next page
Document Version 2010-08
Press "SETUP" when it is displayed.
ENTER Select "Disable"
for DHCP setting.
1
ENTER
Subnet Mask Address*
ENTER
Default Gateway Address*
ENTER
Select "PBX".
ENTER
PBX IP Address
4.5.1 Assigning the IP Addressing Information
SETUP
Select "IP Address".
2
3
Select "PBX IP ENTER
Address".
ENTER
ENTER
ENTER
ENTER
Select "Secondary
PBX".
IP Networking Guide 55