Panasonic KX-NCP500 Networking Manual page 41

Note
For more details about gateway settings, refer to "3.11 [1-1] Slot—Shelf Property - Virtual IP Gateway—
GW Settings" in the PC Programming Manual.
Document Version 2010-08
4.2.2 Programming the Address Translation Table
3. a.
Click DN2IP.
b.
When using the PBX code method:
In the Leading Number box, type the remote PBX
code and starting digit of destination extension.
When using the extension number method:
In the Leading Number box, type the remote PBX
code and starting digit of destination extension.
c.
In the Remaining Number of Digits box, type a
number of digits to dial following the leading number.
d.
In GW No./GW Group Selection, select GW No.
e.
In the GW No. box, select 1 (the gateway entry for
the destination gateway device at the remote PBX).
f.
Click OK.
IP Networking Guide 41