Connect Pc - Metz Axio pro Operating Instructions Manual

33. Connecting a PC: PC [VGA] ➜ TV set [DVI-A]
Start your PC and preset the resolution to
1024 x 768p 60 Hz. Exit windows and
turn the PC off.
VGA ➜ DVI-A setting
• Call up the TV menu with the key
• Open the "AV devices" menu with the
yellow button
• Use the cursor control key
the "PC" AV device and then press the
key . Use the cursor control key
to go to the "Signal types" menu item
and press.
made as shown in Figure 1a.
• Exit the menu with the key
Press the key
seconds and then select the AV device
"PC".
• Connect the VGA output of the graphic
card of the PC with the DVI input of
your TV set with a multimedia cable
(VGA, 15pol. (plug) to DVI (plug) (Pic-
ture 2).
fig. 1a
AV devices
Signal OUT
130
.
to select
. the settings must be
. .
for approx. three
F1
Front HDMI
AV-Receiver
Other device 1
Other device 1
PC
Satellite / set top
DVD Player 2
DVD Player 1
DVD/Videorec.2
DVD/Videorec.1
DVI-D Signal IN
• Switch the PC on. When the picture of
the PC is shown on your TV for the first
time, a box is displayed on the bottom
edge of the screen with the resolution
that has been set, e.g.:
.
Video: 1024 x 768 60Hz
☞
You can call up this information at
any time by pressing the green
While Windows is starting, data is
exchanged between the graphics card and
the TV. The possible resolutions are deter-
mined in the process.
When the start-up procedure is finished,
you can set the resolution as you wish
(recommended = 1360 x 768 - 60 Hz.) in
the Windows menu "Display characteri-
stics".
For PC sound from the speakers of your
TV, see page 132.
Name
Signal types
✗
Connect
no Signal
button.
DVI-A
fig. 2
VGA