Table of Contents
Advertisement
IPECS
Release 5
Feature Description & Operation
3. Dial the Account Code (1 to 12 digits).
4. Press '*'.
Conditions
1. When entering an Account Code during a call, DTMF digits are not heard by the connected
party.
2. A maximum of 1000 {
3. If an Authorization Code is entered as the Account Code, the SMDR record will show the
station number or the bin number for a System Authorization Code rather than the user entered
Authorization Code.
Programming
N
UMBERING
Related Features
Authorization Codes (Password)
SMDR (Station Message Detail Recording)
Station Flexible Buttons
Hardware
2.2 A
S
LARM
IGNAL
Description
The system can be configured to recognize the status of an external contact (normally open or
closed). The system will signal assigned iPECS Phones when the contact activates. This capability
is commonly employed to provide remote Alarm or Door Bell signals to the user.
Assigned stations receive the Alarm Signal, either a single tone burst repeated at 1-minute intervals
or a continuous tone. The Alarm Signal may be terminated at the user's phone by dialing the Alarm
Stop code or, if assigned, pressing the {
condition must be cleared and the Alarm signal terminated.
When used as a Door Bell, assigned iPECS Phones receive a single tone burst each time the
external contact is activated and no reset is required.
Operation
System
At detection of contact operation, the Alarm/Door Bell signal is sent to assigned stations.
iPECS Phone
To assign a Flex button as an {
[
] + {
PGM
FLEX
-
ONE
TOUCH ACCOUNT CODE
1. Flexible Numbering Plan (PGM 106-Btn 8)
/D
B
OOR
ELL
ALARM STOP
ALARM STOP
} + '565' + [
]
SAVE
} buttons may be assigned in the system.
} button. To rearm the Alarm function, the alarm
} button to terminate the Alarm Signal:
2-2
5.0
Advertisement
Table of Contents
