Step 3. Obtain The Ap20 Access Point Ip Address; Step 4. Program The Ap20 Access Point - NEC ML440 Quick Setup Manual

Step 3. Obtain the AP20 Access Point IP Address

1. From an adequately charged ML440 Handset, press
2. Press and dial
MENU
3. The IP address of the AP20 Access Point will show on the handset display. Make a note of it.

Step 4. Program the AP20 Access Point

1. From a PC on the site LAN (same subnet as the AP20 Access Point), launch a web browser.
2. In the browser address line, type the IP address of the AP20 Access Point and press
3. Log into the AP20 Access Point Administration Program using the default credentials.
Username = admin
Password = admin
4. In the Servers screen:
SIP Server: Enter the DSX LAN IP address followed by the SIP port (e.g., 172.16.3.3:5060)
Registration time(s): Leave at default.
DTMF Signalling: Select RFC 2833.
Codec Priority: Remove all codecs except for G711U.
Click Save to save your entries.
5. In the Network screen:
IP settings: Leave DHCP/Static IP: set at DHCP.
VLAN Settings: Leave at default. These settings are not used by DSX.
DHCP Options: Set Plug-n-Play to Disabled.
NAT Settings: NAT Traversal is currently not supported in the AP20 Access Point. Leave at default (Disabled).
SIP/RTP Settings: Set Local SIP port: to 5060 and SIP registration mode: to Static. Leave the other options
at default.
Click Save to save your entries.
6. In the Extensions screen, click
register:
Extension: Enter the DSX IP extension number that will be assigned to the ML440 handset.
Authentication User Name: As above, enter the DSX IP extension number that will be assigned to the ML440
handset.
Authentication Password: Enter the password for the DSX IP extension assigned in Stations: Con g: Setup:
VoIP: Password (2106-02).
Display name: For simplicity, enter the name for the DSX IP extension assigned in Stations: Con g: Setup:
Type: Name (2101-02). The ML440 automatically uses the extension name programmed into the DSX.
Server: Normally, there is only one server in the list and it corresponds to the entries you made for the DSX
system in the Servers screen.
Click to save your entries and return to the previous screen.
Save
ML440 Wireless IP DECT Quick Reference Guide
DSX |
(*47*).
*IP*
Add extension and make these entries for each ML440 Handset you want to
MENU .
| 7
.
Enter