NEC ML440 Quick Setup Manual page 48

ML440 Wireless IP DECT Quick Reference Guide
48 | DSX |
Multi Cell Status
System Information:
Last packet received
from IP:
Settings for this unit
Multi cell system:
System chain ID:
Synchronization time
(s):
Multi cell debug:
Save and Reboot:
Save:
Cancel:
Table 11: Configuration
Use the Con guration screen to backup and restore the AP20 Access Point con guration. This screen also
shows the contents of the saved con guration database.
Shows the multicell mode when enabled.
When multicell is enabled, shows the IP address, date, and time of the last packet
received from a synchronized AP20 Access Point.
To include the AP20 Access Point in a multi-cell installation, select Enabled.
This is a unique identi er for the multi-cell chain your are setting up. Each AP20
in the chain should have the same System chain ID.
The AP20 Access Points in the chain automatically re-synchronize after this
interval. Leave this setting at default (60 seconds).
Select None.
Click to save your changes and reboot the AP20.
Click to save your changes without rebooting.
Cancel your new entries. The settings will return to their previously saved values.