NEC ML440 Quick Setup Manual page 44

ML440 Wireless IP DECT Quick Reference Guide
44 | DSX |
Enable RPORT:
Keep alive time:
SIP/RTP Settings
Local SIP port:
SIP ToS/QoS::
RTP port:
RTP port range:
RTP ToS/QoS:
SIP registration mode:
Save and Reboot:
Save:
Cancel:
Table 5: Management
In addition to allowing you to enter a custom name for the AP20 Access Point, the Management screen
provides the options for setting up logs and traces. If you want to take advantage of these maintenance
options, refer to Appendix A in the ML440 and AP20 System Installation Guide (NDA-31192) for more.
Base Station Name:
SIP Log Server
Address:
Management Transfer
Protocol:
Upload of SIP Log:
Trace Server:
This option is not yet available.
This option is not yet available.
Leave this setting at default (5060).
Not used by DSX.
Leave this setting at default (50004).
This option is not yet available.
Not used by DSX.
Set to Static. Plug-n-Play is not applicable to DSX.
Save the entries on this page and immediately reboot the AP20 Access Point.
With DSX you would not normally have to do this.
Save all the entries on the page.
Cancel any new entries you have made to the on-screen settings. The settings
will return to their previously saved values.
Enter a descriptive name for the AP20 Access Point.
Refer to Appendix A in the ML440 and AP20 System Installation Guide
(NDA-31192) for more on these option.