Call Forwarding - NEC ML440 Quick Setup Manual

• Calls to a UCD Group master number
• Calls ringing a Group Ring master number
• Transferred calls
When the Feature Key is:
Off
On
Slow Flash
Fast Flash
To answer a call ringing or ashing a Call Coverage Feature Key:
1. Press the flashing Call Coverage Feature Key.
2. You'll pick up the covered call.
To place a call from an idle Call Coverage Feature Key to the covered extension:
1. Press the Call Coverage Feature Key.
a) You hear two beeps or Intercom ringing.
2. Speak with the co-worker at the covered extension.
a) The Call Coverage Feature Key lights while you are connected.
To Transfer your call using a Call Coverage Feature Key:
1. Do not hang up.
2. Press Transfer (soft key 3).
3. Press your Call Coverage Feature Key.
4. Do one of the following.
a) Announce the call to make a Screened Transfer.
• Hang up if your co-worker accepts the call.
b) Hang up to send the call through as an Unscreened Transfer.
c) Press the flashing line key to return to the call if your co-worker doesn't want it.
5. When you Transfer a call, it will recall to you if it is unanswered at the destination. If you don't answer the recall,
it diverts to Key Ring.

Call Forwarding

Call Forwarding cannot be set up, enabled, or disabled at an ML440 handset. Use the system's built-in
Phone Manager instead.
ML440 Wireless IP DECT Quick Reference Guide
DSX |
Call Coverage Key Busy Lamp Indications
The covered extension is:
Idle or not installed
Busy
Ringing
Covered extension is in DND.
| 19