Extension Hunting; Flash; Forced Line Disconnect - NEC ML440 Quick Setup Manual

ML440 Wireless IP DECT Quick Reference Guide
24 | DSX |
b) You can press a Hotline or Call Coverage Feature Key for the Door Box instead of dialing the extension
number.
To answer Door Box ringing:
1. Press TALK .
2. Talk to the visitor at the door.
To activate the Door Box relay (which in turn controls the door strike):
1. Place or answer a Door Box call.
2. Push a specially-programmed Flash Feature Key to open or close the Door Box relay.

Extension Hunting

Extension Hunting is disabled by default.
To temporarily install or remove your extension from your UCD group:
1. Press TALK.
2. Dial .
*5
3. Do one of the following:
a) Dial 4 to return your extension to your group.
b) Dial 6 to remove your extension from your group.

Flash

Flash is enabled by default, but the ML440 handset does not have a specially-programmed Flash Feature
Key.
To Flash the outside line you are on:
1. Press your specially-programmed Flash Feature Key.
2. The system will send a Flash signal to the outside line.

Forced Line Disconnect

Forced Line Disconnect is disabled by default.
To disconnect a busy line:
1. Do one of the following
a) Press the line key for the busy line.
b) Press TALK
2. When you hear busy tone, dial
3. You hear Intercom dial tone and the line key goes out.
a) You can now place a new call on the line.
and dial the line's extension number (e.g., 101 for line 1).
# to disconnect the line.