Tandem Calls / Unsupervised Conference - NEC ML440 Quick Setup Manual

To call a System Speed Dial number:
1. Press and dial
TALK #
2. Dial the System Speed Dial entry number (e.g., 201).
a) You can optionally press a System Speed Dial Feature Key and skip steps 1 and 2.
To call a Personal Speed Dial number:
1. Press TALK and dial #
2. Dial the Personal Speed Dial entry number (701-720).
a) You can optionally press a Personal Speed Dial Feature Key and skip steps 1 and 2.
Some other Speed Dial options:
1. To chain (link) stored numbers, wait for the rst number to dial out and then press a Speed Dial Feature Key for
the second number.
You cannot chain (link) Intercom numbers.
2. If the programmed route is busy, you can press an idle line key to reroute the call.

Tandem Calls / Unsupervised Conference

Tandem Calls are disabled by default.
To set up a Tandem Call:
1. Place or answer an outside call.
2. Press the soft key (soft key 2).
Conf.
a) Your hear Intercom dial tone.
b) Your caller hears Music on Hold (if installed) while they wait for you to set up the Conference.
3. Place or answer another outside call.
a) You can optionally retrieve a call from Park Orbit.
4. Press Conf. (soft key 2) to set up the Conference.
a) If you cannot add additional parties to your Conference, you have exceeded the system's Conference limit.
5. Press END to hang up.
a) The line/loop keys for the outside lines stay on.
b) If the outside parties immediately disconnect, the lines you selected or your extension does not have Tandem
Call capability.
To disconnect a Tandem Call (using Forced Line Disconnect):
1. Do one of the following:
a) Press the line key for one of the busy lines.
b) Press and dial the line's Direct Line Access code (e.g., 101 for line 1).
TALK
2. Dial to disconnect the Tandem Call.
#
3. Press END to hang up.
ML440 Wireless IP DECT Quick Reference Guide
DSX |
.
.
| 35