Matrox MXO2 Installation And User Manual page 79

monitor, you can change the setup to 0 IRE to output your DV clips at
the correct brightness.
7.5 IRE
•
YUV/RGB
$
that is sent from the component output. For example, select RGB - native
if you connected the component output to a device that accepts an RGB
signal.
Under HDMI Output , you can specify your HDMI output format and type.
5
Format Use this to specify whether you want the format for your
$
HDMI output to be the same as the main or secondary output.
YUV/RGB
$
the HDMI output:
YUV Outputs YUV HDMI video. Select this only if you connected
•
the HDMI output to a device that accepts a YUV signal.
RGB - calibrated
•
currently loaded Matrox HDMI calibration settings for your HDMI
monitor or television. For details on calibrating your HDMI monitor
and loading calibration settings using the Matrox HDMI Calibration
Utility, see
RGB - native
•
any calibration compensation. This is useful when you want to output
RGB HDMI video to a device other than an HDMI monitor or
television, such as an HDMI recorder to perform an export to tape.
Under SDI Output , specify whether you want the format for your SDI
6
output to be the same as the main or secondary output.
Under Advanced , you can specify advanced video output settings.
7
Analog SC/H Phase
$
video output's subcarrier phase with respect to the horizontal sync of the
genlock source (for composite video only).
Allow Super White/Allow Super Black
$
to allow the highest luminance level of your video output to exceed the
standard maximum white level. Select Allow Super Black to allow the
lowest luminance level of your video output to fall below the standard
black level. These options apply to all video outputs.
¦ Note
Super white and super black should not be allowed when producing
your final video production for broadcast.
Click OK to save your settings.
8
Applies the standard NTSC setup level of 7.5 IRE.
Select YUV or RGB - native to set the type of video signal
Select the type of video signal that you want to be sent from
Outputs adjusted RGB HDMI video using the
Chapter 7, "Calibrating Your HDMI Monitor for
Outputs native RGB HDMI video that does not apply
Use this slider to advance or delay your analog
Select Allow Super White
Defining your sequence settings
59
Video."