Matrox MXO2 Installation And User Manual page 114

94
To review or change your RS-422 device control settings, click Device
6
Options
dialog box as explained in
page
Under Export to Tape Mode , you can specify the type of export you want
7
to perform and the tracks you want to be recorded:
$
$
$
¦ Note
capabilities for assemble and insert editing. To perform an insert edit, the edit
mode for Matrox RS-422 device control must be set to Auto Edit or Basic
Edit
Use the transport controls to play back your tape. The current time code of
8
your tape appears in the text box above the transport controls. You can also
use the
L
speed of the shuttling.
Specify where you want the recording to start and stop as follows:
9
$
$
¦ Note
selected In and Out points. When Duration is selected, the Out point is
calculated based on your specified In point and duration.
Click Export to start the export to tape.
10
Chapter 8, Using Matrox MXO2 with Adobe Premiere Pro
. This displays the Matrox RS-422 Device Control Settings
88 (except you won't be able to change the specified port).
Determines the video format for the export to tape. The
Format
available formats depend on your currently selected video output settings
(see "Specifying your video output settings"
your video output settings (MXO2 Mini)"
Assemble Records all tracks (video and audio) sequentially onto the
tape. The control track and previously recorded material on the tape will
be replaced with the material recorded from your sequence.
Insert Records selected tracks (video and/or audio), without affecting
the control track. This lets you perform a video or audio dub. For
example, you can choose to record only video, only selected audio tracks,
or video and selected audio tracks from your sequence.
Check your device's documentation to determine its recording
as explained in "Setting up Matrox RS-422 device control"
, , and shortcut keys to control the shuttle. Press
J K L
to shuttle right, and
K
Click the Set In Point button (
recording to start, or enter the required time code in the In box.
Click the Set Out Point button (
recording to stop, or enter the required time code in the Out box.
Alternately, you can select Duration and enter the duration you want for
the recording. The Out point will then be calculated for you. By default,
the duration is set to the duration of the work area. You can click Reset at
any time to set the duration back to the duration of the work area.
When Out is selected, the duration is calculated based on your
"Setting up Matrox RS-422 device control"
to stop. Pressing or
J
) to specify where you want the
) to specify where you want the
on page 57 and "Specifying
on page 60).
on page 88.
to shuttle left,
J
multiple times increases the
L
on