Exporting To Tape Using Matrox Rs-422 Device Control - Matrox MXO2 Installation And User Manual

Exporting to tape using Matrox RS-422 device
control
With Matrox RS-422 device control, you can perform either an insert or assemble
edit to record your Matrox sequence onto tape as follows:
Open your project, activate the Matrox sequence that you want to export to
1
tape, and position the work area bar over the section of the sequence that you
want to export.
If you haven't already done so, play back your sequence and render any
2
non-realtime sections that are identified with a red render bar.
Make sure that you've properly connected your recorder and configured
3
Matrox RS-422 device control as explained in
device control" on page 88.
Load a striped recordable tape into your recorder, and set your recorder to
4
Remote or VTR mode.
Choose File > Export > Tape to display the following dialog box:
5
"Setting up Matrox RS-422
Exporting your sequence to tape
93