Motion Event
Motion– On/Off [Specify for each channel]
Sensor Event
Enable/Disable individual sensors on each channel; Click All to enable/disable all sensors on that channel.
Video Loss
The Video Loss feature is designed to report video loss for any camera on a specified channel.
Select/Clear individual channels on each camera; Click All to select/clear all channels on that camera.
Event Record Setup
Day/Night/Weekend – Adjust the FPS and picture quality for each schedule individually
Record On / Off – On/Off [Enable Event Recording]
FPS – 0 >30 [Define a global FPS setting or set individually for each channel]
QUALITY – Low > Normal > Fine > SuperFine [Define a global quality setting or set individually for each channel]
Day Frame / Night Frame / Weekend Frame – Displays the actual FPS / maximum FPS
HDD Setup
Disk Overwrite – Enable / Disable [Select the check box to enable the DVR to write over old data when the hard drive is full.]
Disk Full Warning – Enable/Disable [Enable Disk Full Warning for notification when the HDD becomes full and HDD Overwrite is
disabled.]
Remain Time – 0>60 [Define the amount of remaining recording time to trigger the Disk Full Warning.]
Used Space – 80>99 [Define the percentage HDD used that triggers the Disk Full Warning.]
Disk Full Alarm – 0>8 [Define which relay will be triggered upon a full Hard Disk.]
Disk Full Buzzer – Enable/Disable [Enable a continuous buzzer to sound for Disk Full Warning.]
Disk Full Message– Enable/Disable [Enable a popup message to display for Disk Full Warning.]
Sensor Setup
Sensor
Sensor – N/O >N/C [Set sensors to Normally Open or Normally Closed]
Alarm Out – Off > On [Set Relay switches to Off or On]
NOTE: This section located in the Record > Event Setup section on the E120 server.
27717AH
47