Table of Contents
Advertisement
NETWORK
NETWORK SETUP
Configure network settings.
DHCP
Select – System gets IP address from DHCP server.
Clear – User must manually define a static IP
address. Contact the network administrator for this
information.
Host Name – The DVR name.
IP Address – DHCP or Static. Contact your network
administrator for this information.
DDNS Server – The current DDNS server (default: NONE). See
the instructions below to enable the free DDNS service.
ID – Factory set for Dynamic DNS.
Password – Factory set for Dynamic DNS.
Host Name – The DVR name as it will appear on the network
and through the DDNS server. (Example: OE123456)
Contact technical support if you wish to change this name.
Enabling Free DDNS
Your E-Series DVR comes with a free five-year DDNS service, pre-configured using OpenEyeDVR.com. DDNS service enables the DVR
to connect remotely to a server that does not have a fixed IP address.
NOTE: You must contact your network administrator to complete router configurations for the DDNS service to work.
1.
Select NETWORK SETUP > NETWORK.
2.
Select DDNS SERVER under DDNS and press ENT.
3.
Select openeyedvr.com.
NOTE: The DVR is preconfigured with the appropriate password and settings for the free DDNS service. If you load the default
network system settings refer to the Read This First document for the DDNS settings. Please contact Technical Support if assistance
is required.
24
NETWORK SETUP - NETWORK
NETWORK
DHCP
HOST NAME dvr
IP ADDRESS
000.000.000.000
SUBNET MASK
000.000.000.000
GATEWAY
000.000.000.000
DNS
000.000.000.000
DDNS
DDNS SERVER
openeyedvr.com
ID
xxxxxxxxx
PASSWORD
****
HOST NAME
xxxxxxxxx
ROUTER IP
OFF
STATUS
CHECK UNCHECKED
NETWORK
SERIAL
SAVE
CLIENT
E-MAIL
CANCEL
27717AH
Advertisement
Table of Contents
