Table of Contents
Advertisement
MOTION/EVENT SETUP
Motion / Event Setup has four sections; Input, Sensor, Action, and EA (Emergency Agent). When and event comes in (Input) the
DVR records the image according to its settings (Camera Setup) and triggers an alarm (Action).
Input Setup
CH –
Channels 1~8 /
MOTION – ON/OFF [Specify whether to use motion input or
not.]
LEVEL – Low / Normal / High / Highest [Sensitivity]
AREA – Define the motion detection area.
SENSOR/VIDEO LOSS – Specify ON/OFF for each type of
event.
Note
For Motion Area settings see Motion Detection
Recording later in this manual.
Sensor Setup
Sensor Setup
1.
Use the arrow buttons to select Sensor 1 and press
ENT to change to N/O (Normally Open) or N/C
(Normally Closed).
2.
Repeat for all sensors.
3.
Select SAVE and press ENT to save settings and exit
SENSOR SETUP.
Relay Setup
1.
Use the arrow buttons to select Relay 1 and press ENT
to turn OFF and ON.
2.
Repeat for all relays.
3.
Select SET and press ENT.
4.
Select SAVE and press ENT to save settings exit
SENSOR SETUP.
27717AN
Channels 9~16
MOTION/EVENT SETUP - SENSOR
NO.
TYPE
1
N/O
2
N/O
3
N/O
4
N/O
5
N/O
6
N/O
7
N/O
8
N/O
9CH-16CH
INPUT
SENSOR
SAVE
CANCEL
NO.
SIGNAL
1
ON
2
ON
3
ON
4
ON
SET
CLEAR
ACTION
EA
33
Advertisement
Table of Contents
