Connecting To A Sensor Input; Connecting To A Relay Output; Turning On The Dvr - OpenEye OE2-E12016 User Manual

CONNECTING TO A SENSOR INPUT

To make connections on the Alarm Connector Strip, press and hold the button and insert the wire into the hole above the button. To
disconnect the wire press and hold the button below the wire and pull out.
Alarm In
Use external devices to send a signal to the DVR when an event
occurs. Mechanical or electrical switches can be wired to the
Alarm In and Ground (GND) connectors.
NOTE: All connectors marked GND are common. Connect the ground side of the alarm input and/or alarm output to the GND
connector.

CONNECTING TO A RELAY OUTPUT

To make connections on the Alarm Connector Strip, press and hold the button and insert the wire into the hole above the button. To
disconnect the wire press and hold the button below the wire and pull out.
Alarm Out
The DVR can activate external devices such as buzzers or lights.
Connect the external device to the Alarm Out and Ground (GND)
connectors. See Alarm Setup in the manual for more details.

TURNING ON THE DVR

1. Connect the power cable.
2. Connect camera cables.
3. Connect a network cable and a monitor cable.
4. Flip the power switch on the back of the DVR and wait until the main screen is displayed on the connected monitor; this process
will take approximately two minutes.
10
(See the Connection Guide section for more details)
27717AH