SERIAL SETUP
Configure connected serial devices.
Type – None > External Controller > Text-In
External Controller
Model – Select appropriate model from the supported list.
Port – [Baud Rate / Data Bit / Parity / Stop Bit]
Text-In
Target – [User Defined]
Port – [Baud Rate / Data Bit / Parity / Stop Bit]
Supported External Controller Models:
•
OPTIX 500J
•
Hitron HID2404CEN
•
Hunt HKB-300
•
7323 DKB-06
CLIENT SETUP
Configure general remote access
Remote Port – Use this port number when configuring remote
access software. The default port is 2000 but can be changed.
Web Port – Used for remote connections using a web browser.
This port should be open on the router. Default web port is 80.
Remote Configuration – Enable to allow an administrator to
change configurations using remote access software.
Max Transfer Speed – Set network bandwidth. If the network is
low speed, set this value as the network (aka. Bandwidth
Throttling).
27717AH
•
05-255
•
WC-2500/3000J
•
WTX-1500/2000
NETWORK SETUP - SERIAL
RS232
TYPE
EXTERNAL CONTROLLER
MODEL
NONE
PORT
9600-8N1
RS485
TYPE
TEXT-IN
TARGET
NONE
PORT
9600-8N1
NETWORK
SERIAL
SAVE
NETWORK SETUP - CLIENT
REMOTE PORT
2000
WEB PORT
80
REMOTE CONFIG
ENABLE
MAX TRANSFER SPEED
100 Mbps
NETWORK
SERIAL
SAVE
CLIENT
E-MAIL
CANCEL
CLIENT
E-MAIL
CANCEL
25