Save Configuration; Dual Image Configuration - HP ProCurve 1810G Management And Configuration Manual

Maintenance Pages

Save Configuration

Save Configuration
Use the Save Configuration page to save any changes applied since the last reboot. If the switch reboots
before the applied changes are saved, the changes will be lost. To access this page, click
Maintenance > Save Configuration.
Figure 10-4. Save Configuration Page
Click Save Configuration to save the changes made during this session.
■

Dual Image Configuration

Use the Dual Image Configuration page to name and change the next bootup image. To access this
page, click Maintenance > Dual Image Configuration.
The Dual Image Configuration allows activating either of the stored images: Image1 or Image2. When
one image is activated, the other image serves as a backup; if Image1 either fails or does not boot, then
the other image can be activated.
As shown in Figure 10-5, the current active image is Image2. Image1 can be set to be activated, deleted,
or an image description can be applied.
Figure 10-5. Dual Image Configuration Page
10-9